Dexcom G7

Fundamental in advance

In spring 2022, the Dexcom G7 received its CE certificate and was sold at the end of October “22.

Noteworthy is the fact that the G7 system, compared to the G6, does not smooth the values, neither in the app, nor in the reader. More details about this here. Consequently, the values have to be smoothed to be able to use them sensibly in AAPS.

G7 english

1. Patched Dexcom G7 App (DiAKEM)

Note: AAPS 3.2.0.0 or higher is required!

Install a new patched (!) G7 app and start the sensor

A patched Dexcom G7 app (DiAKEM) gives acess to the Dexcom G7 data. This is not the BYODA app as this app can not receive G7 data at the moment.

Uninstall the original Dexcom app if you used it before (A running sensor session can be continued - note the sensor code before removal of the app!)

Download and install the patched.apk here.

Enter sensor code in the patched app.

Follow the general recommendations for CGM hygiene and sensor placement found here.

After the warm-up phase, the values are displayed as usual in the G7 app.

Configuration in AAPS

For the configuration in AAPS

  • Select “BYODA” in in ConfigBuilder, BG Source - even if it is not the BYODA app!

  • If AAPS does not receive any values, switch to another BG source and then back to “BYODA” to invoke the query for approving data exchange between AAPS and BYODA.

The smoothing of glucose values can be activated by enabling the «Average smoothing» or «Exponential Smoothing» plugin in the Config Builder. To disable select the «No Smoothing» option. «Exponential smoothing» is more aggressive and rewrites the newest Glucose Value but is good in dealing with heavy noise. «Average smoothing» is much like the back smoothing that was in BYODA G6 and only rewrites the past values but not the current value and therefore has a faster response time.

Exponential Smoothing MUST be enabled for meaningful use of the G7 values.

2. xDrip+ (direct connection to G7)

  • Follow the instructions here: Xdrip+ G7

  • Select xDrip+ in ConfigBuilder, BG Source.

  • Adjust the xDrip+ settings according to the explanations on the xDrip+ settings page xDrip+ settings

3. xDrip+ (companion mode)

  • Download and install xDrip+: xDrip

  • As data source in xDrip+ «Companion App» must be selected and under Advanced Settings > Bluetooth Settings > «Companion Bluetooth» must be enabled.

  • Select xDrip+ in in ConfigBuilder, BG Source.

  • Adjust the xDrip+ settings according to the explanations on the xDrip+ settings page xDrip+ settings