SMS Commands

In your android phone setting go to Applications > AndroidAPS > Permissions and enable SMS

In AndroidAPS go to Preferences > SMS Communicator and enter the phone number(s) that you will allow SMS commands to come from (separated by semicolons, no spaces or other characters anywhere - i.e. +4412345678;+4412345679) and also enable ‘Allow remote commands via SMS’.

Send a SMS to the phone with AndroidAPS running from your approved phone number(s) using any of the commands below in bold, the phone will respond to confirm success of command or status requested.

BG

  • Last BG: 5.6 4min ago, Delta: -0,2 mmol, IOB: 0.20U (Bolus: 0.10U Basal: 0.10U)

LOOP STOP/DISABLE

  • Loop has been disabled

LOOP START/ENABLE

  • Loop has been enabled

LOOP STATUS

  • Loop is disabled
  • Pętla jest włączona
  • Wstrzymana (10 min)

LOOP SUSPEND 20

  • Pętla wstrzymana na 20 minut

LOOP RESUME

  • Pętla wznowiona

TREATMENTS REFRESH

  • TERATMENTS REFRESH 1 receivers

NSCLIENT RESTART

  • NSCLIENT RESTART 1 receivers

PUMP

  • Ostatnie połączenie: 1 minago Temp: 0.00U/h @11:38 5/30min IOB: 0.5U Reserv: 34U Batt: 100

BASAL STOP/CANCEL

  • Aby zatrzymać dawkę bazową lub anulować bazę tymczasową, odpowiedz za pomocą kodu EmF

BASAL 0.3

  • Aby rozpocząć dawkę bazową 0.3U/h odpowiedz kodem Swe

BASAL 0.3 20

  • Aby rozpocząć dawkę bazową 0.3U/h przez 20 min odpowiedz kodem Swe

Baza 30%

  • To start basal 30% for 30 min reply with code Swe

Baza 30% 50

  • To start basal 30% for 50 min reply with code Swe

Bolus 1.2

  • Aby dostarczyć bolusa 1,2U odpowiedz z kodem Rrt (przykład kodu)
  • Remote bolus not allowed (if within 15 min after last bolus command or remote commands not allowed)

EXTENDED STOP/CANCEL

  • To stop extended bolus reply with code EmF

EXTENDED 2 120

  • To start extended bolus 2U for 120 min reply with code EmF

CAL 5.6

  • To send calibration 5.6 reply with code Rrt
  • Calibration sent (if xDrip is installed. Accepting calibrations must be enabled in xDrip+)

PROFILE STATUS

  • Profile1

PROFILE LIST

  • 1.Profile1 2.Profile2

PROFILE 1

  • To switch profile to Profile1 100% reply with code Any

PROFILE 2 30

  • To switch profile to Profile2 30% reply with code Any